3.5-mm-Locking-Clavicle-Hook-Plates

3.5 mm Locking Clavicle Hook Plates Specification
Plates available holes are 4, 5, 6, 7 and 8.
Plates available for Left and Right both direction
Plates are available with 3 different hook depths- 12 mm, 15 mm and 18 mm.
Plate has combi holes and round holes. Combi holes allow fixation with locking screws in the threaded section and cortex screws in the dynamic compression unit section for compression.
The shaft holes accept 3.5 mm locking screws in the threaded portion or 3.5 mm cortical screws or 4 mm cancellous screws in the compression portion.
3.5 mm Locking Clavicle Hook Plates allow implant placement to address the individual fracture pattern.
Anatomically precontoured, rounded shaft profile minimizes the risk of soft tissue irritation between the plate and surrounding soft tissue, the acromioclavicular joint and the rotator cuff, undercuts in shaft reduce impairment of blood supply, wide variety of plates optimize implant selection.
Limited-contact surface reduces bone-to-plate contact and helps to preserve the periosteal blood supply.
Choice of different lengths of plate eliminates the need to cut plates.
Pre-contoured plate to match anatomical shape.
Available in both Titanium and Stainless steel.
locking plate increases construct stability, decreases risk of screw back-out and subsequent loss of reduction. It also reduces the need for precise anatomic plate contouring and minimizes the risk of stripped screw holes.
A complete Instruments Set is available for 3.5 mm Locking Clavicle Hook Plates. General Instruments are available for this plate such as Plate Bending Press, Plate Holding Forceps, Plate Bending Pliers, Bone Holding Forceps, Bone Elevators, Bone Cutter, Bone Nibbler, Depth Gauge, Sleeve, Screw Driver, Trocar Sleeve etc.
3.5 mm Locking Clavicle Hook Plates Uses
3.5 mm Locking Clavicle Hook Plates are used for fixation of lateral clavicle fractures and dislocations of the acromioclavicular joint.